Fanox Electronic - SIA-E Self-Powered relay

SIA-E Self-Powered relay

50P, 50N, 51P and 51N protection functions
Self-powerred overcurrent protection relay starts up from 5 A of primary single phase
Reduces the operating cost of the centre: Installations and maintenance of batteries
Can be temporarily supplied by an external battery
Events can be recorded (optional) and specific test menu is provided depending on the model
High electromagnetic compatibility
Reduced depth of 80 mm makes it easy to install
Contact-braker protection function by means of trip blocking
External trip, activation of the trip or the coil
Indicates the cause of the trip even though the relay loses the supply (bistable magnetic indicators)
LCD screen allows the parameters to be set and monitored
Uses a specific Fanox current transformer with dual-core.
RS 232 serial port on the front and real RS 485 port on connection terminals. The ModBus RTU protocol is implemented for both ports

Diag func sia e

Dimensiones sia e

The relays have an RS-232 serial port on the front of the equipment with a DB9 connector and an optional rear RS-485 port on connection terminals. The Modbus RTU protocol is implemented for both ports.
The SICom programme with WindowsÆ 2000/XP uses a graphic user interface to allow you to access all equipment information, modify the settings and save events.
The programme can be used locally by using the front port or remotely by using the rear RS485 port.
There are 4 levels of access with user-definable codes.

BATTERY POWER SUPPLY KITCOM

Adaptor that lets you connect two batteries AAA type of 1,5V to the SIA relays using the front RS232 communications port.
The adaptor allows the use of a 12V battery power supply and communication through the port at the same time.
Ensures full operability of the SIA, even when tripping in case of a fault.

Foto ct web CT-DB DUAL-CORE TRANSFORMER

Current transformer for indoor service - no primary coil.
With two secondary coils, one for protection and the other for self-powering (3 days in case of a fault).
For use with the SIA-E protection relay
Highest voltage/Insulation rating: 0.72 kV/3kV
Insulation class: Class B, 130º C
Short-circuit therminal intensity/Dynamic: 20kA - 1s/50kA
Plastic case with resin filling:self-exinguishing, halogen-free UL94-VO
Standard: IEC 60044-1

STRIKER PRT

This is a single effect solenoid. The striker is spring operated.
The striker is activated is activated by low-power polarised electrical signal supplied by the relay in case of a fault.
The striker is reset to its starting position manually.
Travel: 8 mm
Spring strength:
Start of travel: 37 N
End of travel: 18 N
Response time: 4 ms
Protection rating: IP-40

TRIP ADAPTOR TCM

This item is connected to the relay trip outlet and supplies the energy needed to trip the coil.
It is loaded using the auxiliary 230 Vac voltage of the transformation centre and retains power for up to 3 days without external power supply.